How to Stick Down a Peeling Laminate Worktop for a Tidier Kitchen

Affiliate Disclosure: This article contains affiliate links. If you click through and make a purchase, Quick Home Fix may earn a small commission at no extra cost to you. We only recommend products we believe offer genuine value. Read our full disclosure policy.

Step 1: Clean the loose area

Lift the peeling section slightly and wipe away dust, grease and crumbs. The surface needs to be clean and dry for the adhesive to hold properly.

Step 2: Trim damaged edges if needed

Cut away any curled or brittle laminate that will not sit flat again. A neat edge gives the repair a better chance of blending in.

Step 3: Apply adhesive carefully

Spread a thin, even layer of suitable adhesive under the loose laminate and on the worktop base where needed. Follow the curing time so it becomes tacky at the right moment.

Step 4: Press and secure the repair

Lay the laminate back down firmly, then press it with a clean block and hold it in place with masking tape or light pressure while it sets.

Step 5: Check the finish

Once cured, remove the tape and inspect the edge for gaps or raised spots. Wipe away any adhesive marks before using the worktop again.

💡 Pro Tips

• Work in a well-ventilated room when using adhesive.
• Do not overload the repaired edge until it has fully set.
• If water has swollen the chipboard underneath, the fix may not hold well.
• Wipe spills promptly to stop the peeling returning.

⚠️ Safety First

Use adhesives carefully and keep sharp tools away from your fingers. If the worktop base is swollen or rotten, replacing the damaged section may be safer than patching it.